Hello, I have a stormCAD model that I can not get to validate or run because every time I do I get the following error: "The total catchment area 2,676.0 ft² exceeds the total combined area 2,676.0 ft². The total area specified in the subareas collection must equal the total catchment area." Once I fix the area called out in the error, by changing the percentage decimal points, and try running the model, another catchment area will claim to have the same error. I have over 60 catchment areas in one model alone. It would appear the only way to enter catchment area information is to give the over all number for the Area (User Defined) in the Geometry portion of the properties box, and then enter a percentage of separate coverage types in the Subareas portion of property box under Runoff. I remember in Select series 3 you could just enter the areas of each coverage type and it would calculate the overall area of the catchment area. It would appear this procedure is no longer valid for Select Series 4 Thanks!
↧