As shown above, if it is possible to share the same pump station with two discharge pressure setting? Or it is the reason cause error? Coz in my model when I run FF scenario, it results in “failed to converge” “node count” 2. Magg, It doesn't look like your screen capture was displayed above your question. Here are some things you might try or have a look at: 1) Are there any user notifications that are displayed that indicate a problem after you run your model? 2) Have you tried to run the Analysis Validate tool and check the user notifications for issues? If those don't help perhaps you want to upload your model for review. There are two options for sharing your model files on BE Communities. If you would like the files to be visible to other members, compress the files into a zip file and upload them as an attachment using the ‘Advanced Reply editor’ before posting. If your data is confidential, you can follow the instructions in the link below to send it to us via Bentley Sharefile. Files uploaded to Sharefile can only be viewed by Bentley. http://communities.bentley.com/content/bentleysecurefilesupload.aspx Mark
↧