When I look at the Example #5, hydrant flushing are set at junctions instead of hydrants. If I set the Darwin calibration using hydrants, when it simulates multiple flow tests, would it open the hydrants instead of just adding the flow demand? When I run manual calibration (Not using Darwin Calibrator) with a closed hydrant with a demand vs. an open hydrant without demand, the results were significantly different and I found the latter to be a correct setting. I want to make sure that the Darwin Calibration can run multiple hydrant tests as shown in the example by opening each hydrants. Otherwise, I can run only one hydrant test at a time with a specific physical setting, yes? Or perhaps I need to create a junction with the same elevation as hydrants and run the analysis? Yoko
↧