Hello Rohit, It is always better to model the conditions as they are on field, so if you are lifting the water from wet well into next gravity manhole using pump stations, then you should model pump , wet well & pressure pipes as well in the SewerGEMS model. So instead of outfall, you should discharge water into wet-well>pressure pipe>pump>manhole... To understand how to set up wet well, pump, manhole & pressure pipes, please have a look at sample models 3 & 4 located at C:\Program Files (x86)\Bentley\SewerGEMS\Samples. Data required for wet well is base level/elevation of wet well, initial & maximum elevation, its diameter/sizes etc. & that for the pump is pump curve / definition, pump on-off levels, pump elevation, invert level etc. Please have a look at these examples, you will understand how to input data & what is required as well.
↧