Hello Carlos, Darwin Scheduler is still computing, but it is taking a long time to run. One trial in Darwin Scheduler has taken 20 minutes thus far. I believe that this, and likely the error message you are seeing is related to an issue with the representative scenario. If you compute the model, each time step has a network unbalanced user notification associated with it. This message, and any red user notification, is an indication of that there is an error in the model and that the results may not be valid. Before running Darwin Scheduler, I would recommend reviewing your model to resolve the unbalanced network issue. This link has information on doing this. While it appears that you have made some adjustments to the calculation options, the first thing I would do is review the setup of your model. As an example, there are several FCVs that are unable to reach the flow value. This may be expected, as this message will occur if the initial flow value is less than the calculated flow. However, a review on this, as well as any controls and the orientation of the valves is recommended. The link above has some common things that you can try. It also has information on adjustments to calculation options, which may be of further use. Regards, Scott
↧