I think I'll probably have to see your file to understand fully, but if my understanding is correct based on your description of the issue then you'll probably have to enter the information manually, since it is not in the DXF as numeric format that can be extracted automatically. The best way I can think to do that might be to try adding the DXF file as a background over your model. This way at least you'll be able to see where the elevations should be entered. As I stated before though, this will only work if the files are in the coordinate system. That would allow them to line up correctly on top of each other. If you'd like to upload the DXF file there are two options for sharing on BE Communities. If you would like the files to be visible to other members, compress the files into a zip file and upload them as an attachment using the ‘Advanced Reply editor’ before posting. If your data is confidential, you can follow the instructions in the link below to send it to us via Bentley Sharefile. Files uploaded to Sharefile can only be viewed by Bentley. communities.bentley.com/.../bentleysecurefilesupload.aspx Mark
↧